Foam Pollen Filter For Philips Respironics REMstar Devices (Pack of 2)

A dirty inlet filter may cause high operating temperatures that may affect device performance. Under normal usage, the foam filter should be cleaned at least once every two weeks and replaced with a new one every six months. This guide can be done effortlessly and just requires your two hands.

The video below details air filter replacements for CPAP and BiPAP machines. Although this is not specifically the BiPAP S/T device, it can be used as an aid for better understanding.

Step 1

• Disconnect the device from the power source to stop airflow.
• To avoid electrical shock, always unplugged the power cord from the wall outlet before cleaning the device.

Step 2

• Remove the filter from the enclosure by gently squeezing the filter in the center and pulling it away from the device.

Step 3

• Examine the filter for cleanliness and quality. If the foam filter is torn, replace it.
• A dirty inlet filter may cause high operating temperatures that may affect device performance. Regularly examine the inlet filter.

Step 4

• Wash the gray foam filter in warm water with a mild detergent.
• Rinse thoroughly to remove all detergent residue.
• Allow the filter to air dry completely before reinstalling it.
• Never install a wet filter into the device. You must ensure sufficient drying time.

Step 5

• Reinstall the filter.
• To install, insert gray foam filter into the filter area.
• A properly installed, undamaged filter is required for proper operation.

Additional information